SEN02303-00 30 Testing and adjusting 5. Run the engine at high idle, operate the control levers and switches to turn the solenoid valve ON or OFF, and measure the oil pressure. a For the conditions for turning the solenoid valve ON and OFF, see the operation table of each solenoid valve. a The operating condition of the solenoid valve can be checked with the monitoring function of the machine monitor (For details, see “Special functions of machine monitor”). a If the output pressure is as follows, the solenoid valve is normal. Operation table of magnetic separator solenoid valve Operation table of lock cylinder reset solenoid valve Operation table of accessory EPC valve 6.
After finishing measurement, remove the mea- suring tools and return the removed parts.
Operation table of travel junction/2-stage relief solenoid valve Operation table of crusher forward EPC valve Operation table of side conveyor solenoid valve Operation table of radio control travel (Right, left, forward, and reverse) solenoid valve (if equipped) Operation table of travel lock EPC solenoid valve Operation table of feeder forward EPC valve 38 BR380JG-1E0 Operating condition Operation Magnetic separator signal (Magnetic separator ON switch is pressed and magnetic sepa- rator operating signal is ON) ON ON OFF OFF Operating condition Operation Lock cylinder reset signal (Crusher clearance increase or decrease switch is pressed in inspection mode and signal is ON during operation) ON ON OFF OFF Solenoid valve Output pressure OFF (Demagnetization) 0 MPa {0 kg/cm2} ON (Excitation) 2.9 MPa {30 kg/cm2} (Exclude EPC solenoid valve) Operating condition Output pressure MPa {kg/cm2} Primary conveyor signal (Signal is ON for conveyor in operation when primary con- veyor ON switch is pressed) ON Approx.
2.6 {26} OFF 0 {0} Operating condition Operation In travel mode When travel steering signal is ON ON When travel steering signal is OFF OFF In testing mode When crusher clearance reducing switch is ON ON When crusher clearance reducing switch is OFF OFF Operating condition Output: Left MPa {kg/cm2} Crusher forward signal (Crusher speed:
MAX) ON Approx 2.9 {30} OFF 0 {0} Operating condition Operation Side conveyor signal (Side conveyor ON switch is pressed and side conveyor operating signal is ON) ON ON OFF OFF Operating condition Operation Radio control travel signal (Signal is ON for radio control travel in operation) ON ON OFF OFF Operating condition Output pressure MPa {kg/cm2} Conveyor top position Travel mode Travel speed Hi Approx 2.9 {30} Travel speed Lo Approx 1.8 {18.5} Inspection mode 0 {0} Operating condition Output: Left MPa {kg/cm2} Feeder forward signal (Feeder speed: MAX) ON Min. 2.0 {20} OFF 0 {0}