Kaiyi BR380JG-1E0 — MEASURING SOLENOID VALVE OUTPUT PRESSURE

30 Testing and adjusting SEN02303-00 Measuring solenoid valve output pressure 1 a Measuring tools for solenoid valve output pres- sure k Stop the engine and loosen the oil filler cap of the hydraulic tank gradually to release the residual pressure from the hydraulic tank. a Before measuring the solenoid valve output pressure, check that the basic pressure of the control circuit is normal. a Measure the solenoid valve output pressure under the following condition. k Stop the machine on a level ground. q Hydraulic oil temperature: Within operating range 1. Disconnect outlet hoses (1) – (15) of the sole- noid valves to be measured.

a The hoses to be measured are installed to the right side of the main valve. 2. Install adapter N2 and connect the discon- nected hose again. 3. Install nipple [1] of hydraulic tester N1 and con- nect it to oil pressure gauge [2]. a Use the oil pressure gauge of 5.9 MPa {60 kg/cm 2 }. 4. Start the engine. BR380JG-1E0 37 Symbol Part No. Part name N 1 799-101-5002 Hydraulic tester 790-261-1204 Digital hydraulic tester 2 799-401-3100 Adapter (Size 02) No.

Solenoid valve to be measured 1 Travel junction/2-stage relief solenoid valve 2 Magnetic separator solenoid valve 3 Side conveyor solenoid valve 4 Lock cylinder reset solenoid valve 5 Travel lock EPC solenoid valve 6 Accessory EPC solenoid valve 7 Feeder forward EPC solenoid valve 8 Crusher forward EPC solenoid valve 9 Crusher reverse EPC solenoid valve 10 Radio control left travel forward solenoid valve (if equipped) 11 Radio control left travel reverse solenoid valve (if equipped) 12 Radio control right travel forward solenoid valve (if equipped) 13 Radio control right travel reverse solenoid valve (if equipped) 14 Vibratory sieve solenoid valve (if equipped) 15 Secondary belt conveyor solenoid valve (if equipped)