30 Testing and adjusting SEN02304-00 a Entry order of items in table The items are entered in the order of display on the monitoring selection menu screen. a Unit The display unit can be set to ISO, meter, or inch freely (Set it with “Unit selecting” in “Initialization” of the service menu). “CA” in the display unit is an abbreviation for crankshaft angle. “mg/st” in the display unit is an abbreviation for milligram/stroke. a Component in charge MON: The machine monitor is in charge of detection of monitoring information. ENG: The engine controller is in charge of detection of monitoring information. PUMP: The pump controller is in charge of detection of monitoring information.
BR380JG-1E0 19 Code No Monitoring item (Display on screen) Unit (Initial setting ISO) Com- pornent charge Remarks ISO meter inch 02202 Switch Input 7 Key Switch(ACC) ON•OFF PUMP 25500 Solenoid Valve Mag. Sep. Sol. ON•OFF PUMP Lock.Cyl. Unlock PUMP Muck Conv. Sol. PUMP 25601 Relay Drive 0 Horn Relay ON•OFF PUMP Becon Relay PUMP Abno.Press Relay PUMP LockCyl.Push Re. PUMP LockCyl.Pull Re. PUMP Eng. Stop Relay PUMP 25602 Relay Drive 1 Conv. FWD Relay ON•OFF PUMP Conv. REV Relay PUMP 26100 Clearance Potentio Vol. V V V PUMP 26200 Clearance Angle rad ° ° PUMP 26300 Last 0 Clearance Vol.
V V V PUMP 20216 ECM Build Version — — — ENG 20217 ECM CAL Data Ver — — — ENG 18900 ECM Internal Temp °C °C °F ENG 20400 ECM Serial No. — — — ENG 20200 Monitor Prog. Version — — — MON 20227 Monitor Ass'y P/N MON 20402 Monitor Serial No MON 20212 Pump Con. Prog. Version — — — PUMP 20230 Pump Con. Prog. P/N PUMP 20229 Pump Con. Ass'y P/N PUMP 20403 Pump Con. Serial No PUMP