30 Testing and adjusting SEN02305-01 4) After inputting the desired O.S.S. clear- ance, press input confirmation switch (6) to set the input value. 7. “|” lamp (C) goes out to show that the clear- ance adjustment is completed. q Automatic adjustment is carried out with the following procedure. 1) The movable swing jaw plate to the fixed tooth side and the crusher clearance closes. When this happens, portion (E) on the machine monitor flashes. a The set value is saved and is displayed when the next adjustment is made to the clearance. If that value is to be used as it is, there is no need to input the set value again. a If it is desired to abort the setting of the O.S.S.
clearance, press return switch (7). This will return the set value to the original setting. 2) When the swing jaw plate contacts the fixed tooth, the buzzer inside the machine monitor sounds, and crusher actual clear- ance monitor display value (F) is as shown as 0. 6. Adjust the clearance. 1) Use UP switch (4) or DOWN switch (5) to move the cursor on the screen display to position (C). 2) Press input confirmation switch (6) to complete the preparations. “|” lamp (C) flashes. 3) Press input confirmation switch (6) again to carry out the adjustment. “|” lamp (C) lights up and the automatic adjustment is carried out. BR380JG-1E0 7