SEN02305-01 30 Testing and adjusting Check and adjustment of tooth plate wedge bolt spring case, tension spring If there is play in the tooth plate, abnormal noise from around the crusher, knocking noise from the toggle plate, or if the toggle plate has fallen out, stop operations immediately and carry out the fol- lowing check and adjustment. Check that the spring set length is correct and adjust it if there is any problem. The spring set length is as follows. Fixed jaw plate wedge bolt spring A = 0 – 2 mm As shown in the diagram, face (a) (collar face) does not extend to the outside from face (b) (plate sur- face), and the inset is within 2 mm.
k With new machines or with machines where the jaw plate or other consumable parts have been turned or replaced, because of the fitting of parts together dur- ing the first 50 hours (time shown on the service meter), the spring set length and tightening torque of the nuts and bolts may change, so carry out inspection and control thoroughly. If tension spring set length is greater than dimension shown below: q Knocking occurs between the toggle plate and toggle seat, and this will reduce the life of the toggle plate and toggle seat. q The toggle plate may fall out. If tension spring set length is less than dimension shown below: q The tension rod or tension spring may break.
If swing jaw, fixed jaw wedge bolt spring is not suitable: q There may be play in the jaw plate and breakage of the wedge bolt. 12 BR380JG-1E0