Kaiyi BR380JG-1E0 — CHECK AND ADJUSTMENT OF OUTLET CLEARANCE

30 Testing and adjusting SEN02305-01 4. Set mode selector switch (2) to INSPECTION (c) position. The machine monitor switches to the normal inspection screen. a As the crusher is operated, the teeth become worn, so the value displayed on clearance dis- play monitor (A) gradually becomes different from the actual clearance. When this happens, it is possible to compensate for the value by keeping crusher clearance decrease switch (4) pressed to bring the teeth into contact with the fixed jaw plate. 5. Set clearance adjustment selector switch (3) to the M (manual) position. 1. Keep crusher clearance decrease switch (4) pressed to bring the movable teeth and fixed jaw plate into contact.

When the value (A) shows no more change, the movable teeth and fixed jaw plate are in contact. 2. After bringing the movable teeth and fixed jaw plate into contact, keep crusher clearance decrease switch (4) pressed for approx. 10 seconds. 6. Check that mode monitor (D) of the machine monitor has changed to M (manual) mode. 3. The buzzer sounds and the compensation is completed. When this happens, the value on crusher actual clearance monitor (A) changes to 0. a Depending on the wear of the teeth, the value after compensation may not become exactly 0, but this does not indi- cate any abnormality. 7.

Using crusher clearance decrease switch (4) and crusher clearance increase switch (5), adjust so that crusher actual clearance monitor (A) for the amount to change the present clear- ance reaches the target value. (4) Crusher clearance decrease switch Action to close crusher clearance contin- ues while switch is being pressed. (5) Crusher clearance increase switch Action to open crusher clearance contin- ues while switch is being pressed. 4. Press crusher clearance increase switch (5) and adjust so that the value on crusher actual clear- ance monitor (A) becomes the target value.

a After the operation for adjusting the crusher clearance is completed, even if the mode selector switch is turned to the OPERATION mode, the crusher cannot be started while the crusher status lamp is lighted up the yellow (period that crusher operation is prohibited after adjusting clearance: approx. 30 seconds). For details, see “Operation status display lamp in Operation and maintenance man- ual”. BR380JG-1E0 11