Kaiyi BR380JG-1E0 — CHECK AND ADJUSTMENT OF OUTLET CLEARANCE

SEN02305-01 30 Testing and adjusting Toggle plate 1. If distance (C) between the tip of the flange and the bottom of the toggle seat is 278 mm, remove the toggle plate and measure the amount of wear (A) of the toggle plate. For details of the amount of wear of the toggle seat, see “Toggle seat”. 2. Replace if wear amount (A) is approx. 5 mm on one side. Replace also if there is more wear of the one side as shown in the diagram. Wear limit (D): 390 mm When new (E): 400 mm a Use the wear tolerance of toggle seat (2) and toggle plate (1) as a guideline for the above dimension. a When replacing toggle plate (1), replace the toggle plate dust cover also at the same time.

a If noise is generated between toggle seat (2) and toggle plate (1), the noise made when tog- gle plate (1) rolls on the surface of the toggle seat has no effect on the machine itself. If a knocking noise is generated, check if tension spring set length (B) is the specified value. (For details of the tension spring set length, see “Check of jaw crusher and related accessories in Operation and maintenance manual”.) 16 BR380JG-1E0