SEN02305-01 30 Testing and adjusting Replacement of cheek plate 1. Use an air gun or wire brush to remove the sand or soil clogging lifting hole (3) of top cheek plate (1). 3. Fit the tool supplied with the machine to the lift- ing hole, then lift up vertically. If the load is at an angle, it may be difficult to remove. Tools to use Hook: Accessory tool No. 10 2. Loosen cheek plate mounting bolt (4). Next, with the bolt loosened, tighten locknut (5) again. Tools to use Wrench: Accessory tool No. 1 Handle: Accessory tool No. 3 Extension: Accessory tool No. 4 Socket: Accessory tool No. 5 Wrench: Accessory tool No. 7 Pipe: Accessory tool No.
8 k For details of the accessory tool, see “Crusher accessory tool” in Mainte- nance volume of the operation and maintenance manual. k For details of the accessory tool, see “Crusher accessory tool” in Mainte- nance volume of the operation and maintenance manual. 18 BR380JG-1E0