SEN02305-01 30 Testing and adjusting Install the swing jaw wedge bolt spring cover assembly as follows. 1) Raise spring cover assembly (10) with wire and insert into the wedge bolt. 3) Check that spring holder (6) is being pushed into the correct position. (The width of (A) should be 0 – 2 mm.) If it is not being pushed in to the correct position, turn 2 bolts (5) to adjust the holder. 2) Install wedge bolt nut (8) and washer (9). At this point, do not apply the tightening torque to nut (8). 4) Tighten wedge bolt locknut (7). At this time, secure nut (8) so that it will not rotate together with wedge bolt locknut (7).
In addition, secure spring cover assembly (10), too, so that it will not rotate together with wedge bolt locknut (7) and interfere with the swing jaw. 30 BR380JG-1E0