30 Testing and adjusting SEN02305-01 5) Loosen spring holder push bolt (5) so that dimension (B) becomes 15 mm, then tighten locknut (4). 6) Repeat the procedure in Step 3) to check that spring holder (6) is being pushed in to the correct position. If it is not the specified value, adjust again. 3. Wrap a nylon sling around toggle plate (1) and sling it. Replacement of toggle plate 1. Secure the crusher inspection hatch in the open position. 2. Remove the dust prevention rubber plate at the side of the crusher. (left and right) 4. Check that there is no one inside the machine, then start the engine. 5. Set mode selector switch (3) to the inspection position. 6.
Attach a warning tag to announce to those concerned that the machine is now worked on. 7. Press crusher clearance decrease switch (4) on the control box, and move the fixed link for- ward until the fixed jaw plate contacts the fixed jaw plate. BR380JG-1E0 31