SEN02305-01 30 Testing and adjusting 8. If the tooth plates come into contact with each other, stop the engine. 10. Pass the wire through the hole in the bottom of the swing jaw, then use a chain block to pull the crusher case and the track frame and fix them in position. k It is extremely dangerous if you go on to the next work without completely loosening tension spring (2), so remove tension spring nut (M42) from the rod. 11. Check that there is no one inside the machine, then start the engine. 12. Set mode selector switch (3) to the inspection position. 9. Loosen tension spring (2) (both ends: M42) completely. (1) Wrench: Accessory tool No. 2 (2) Pipe: Accessory tool No.
8 k For details of the accessory tool, see “Crusher accessory tool” in Mainte- nance volume of the operation and maintenance manual. 13. Attach a warning tag to announce to those concerned that the machine is now worked on. 14. Press crusher clearance increase switch (5) on the control box, and pull back the fixed link slowly. 15. Stop the engine. 32 BR380JG-1E0