Kaiyi BR380JG-1E0 — CHECK AND ADJUSTMENT OF OUTLET CLEARANCE

30 Testing and adjusting SEN02305-01 16. Take out the toggle plate. 20. Remove the nylon sling fitted to the toggle plate. 4 Toggle plate: 144 kg 21. Install the tension spring and tighten it to the specified tightening length. Set tightening length (C) of the tension spring so that it is 258 – 260 mm when the lock cylin- der length = Min (maximum clearance at crusher addendum). 22. Loosen the chain block installed to the bottom of the swing jaw and remove the wire. 23. Close the crusher inspection hatch. 17. Wrap a nylon sling around the new toggle plate. 24. Install the dustproof rubber plate to the side of the crusher. 25.

Check crusher outlet clearance and adjust it to a desired clearance. For adjusting the crusher outlet clearance, see the section of “Check and adjustment of outlet clearance”. 18. Lower the toggle plate and align it with the cen- ter of the seat at the fixed link end. 19. Loosen the chain block fixed in Step 10, then position it so that the center of the swing jaw contact face of the toggle plate is aligned with the center of the swing jaw toggle seat contact face. When doing this, be careful not let rubber cover (6) on top of the toggle plate get caught. BR380JG-1E0 33