Kaiyi BR380JG-1E0 — CHECK AND ADJUSTMENT OF OUTLET CLEARANCE

SEN02305-01 30 Testing and adjusting Replacement of toggle seat 4. Raise the toggle seat. k Before replacing the toggle seat, follow the items below without fail. After long use, the toggle seat becomes deformed, so it may get stuck to the fixed link or swing jaw. In this case, weld a hook to the center of the toggle seat and pull out the worn toggle seat. In addition, if necessary, take action with the gasket or other part as necessary. (Toggle seat material: Carbon steel) 4 Toggle seat at swing jaw end: 44.5 kg k There is no commonality of the toggle seats, so when installing, be careful not to mistake the assembly combinations.

k To prevent the lock link toggle seat from falling, carry out the operation with the lock cylinder extended to the maximum. 1. Start with removing the toggle plate before- hand, referring to the section dealing with replacement of the toggle plate in this manual. 5. Remove only one toggle seat holder plate (3) at the fixed link end. 2. Remove toggle seat holder plates (1) of the swing jaw at both ends. (Bolts to use: M20 x 8) 6. Screw in an eyebolt (M12) on the side from which a holding plate has been removed and lift up the toggle seat provisionally, taking care not to let it fall. 3. Screw in eyebolts (M12) into tap hole (2) at both ends of the toggle seat and fit the wire. 7.

When the work of lifting up the toggle seat pro- visionally has been completed, proceed to remove a toggle seat holding plate on the opposite side. 8. Insert eyebolts into both ends of the lock link toggle seat, then raise the toggle seat. 4 Lock link toggle seat: 41.7 kg 9. Insert new toggle seats in the reverse order of the works explained above. 34 BR380JG-1E0