30 Testing and adjusting SEN02305-01 Adjusting tension of crusher drive V-belt k If the V belt tension is not normal, the V belts will likely slip when the crusher starts or stops, and shorten the service life of the V belts drastically. Open the V-belt inspection cover, then adjust the V- belt tension as follows. Tools to use Handle: Accessory tool No. 14 or 15 Box wrench: Accessory tool No. 16 k For details of the accessory tool, see “Crusher accessory tool” in Mainte- nance volume of the operation and maintenance manual. 3.
Turn crusher V-belt adjustment turnbuckle (3) to extend distance (L) between the yokes, then adjust the turnbuckle so that tension load (F) for 1 V-belt is 63.6 – 73.6 N {6.5 – 7.5 kg}. (When this is done, deflection (a) is 15 mm.) Tension load (F) is the average value of the measured tension loads for 9 V-belts. Guideline when checking V-belt tension The deflection should be approx. 15 mm when 1 belt is pressed with a finger force of approx. 6 – 7 kg. If the V-belt makes a slipping sound when the crusher is started or stopped, use the following pro- cedure to adjust to the correct belt tension.
L V belt tension adjusting method The V belt tension may be changed by adjusting the turnbuckle located behind the crusher motor. After the adjustment, be sure to tighten the locknut. 1. Open the V-belt inspection window. a F L/2 2. Loosen locknuts (4) and (5) of crusher V-belt adjustment turnbuckle (3). (Locknut (5) turns in the opposite direction to normal.) Tools to use Wrench: Accessory tool No. 1 Wrench: Accessory tool No. 11 B A B J Z 1 3 8 0 7 4. Start and stop the crusher 2 – 5 times. k For details of the accessory tool, see “Crusher accessory tool” in Mainte- nance volume of the operation and maintenance manual. 5.
Measure tension load (F) for 1 V-belt again and check that the measured value is 58.7 – 68.7N {6.0 – 7.0 kg). (When this is done, deflection (a) is 15 mm.) 6. Tighten locknuts (4) and (5). BR380JG-1E0 37