SEN02305-01 30 Testing and adjusting 7. Close the V-belt inspection window. Check and adjustment of primary conveyor 8. Start the engine and turn the fuel control dial to the MAX position. Next, start and stop the crusher and check that there is no slipping sound from the V-belt. If the V-belt slips, it emits a loud noise. k When inspecting and cleaning the primary conveyor and its surrounding, there is always the danger that you are caught in a revolving parts. Be sure to start the work only after stopping the belt conveyor. a There may be a difference in the V-belt tension at the top (A) and bottom (B).
After adjusting the V-belt tension according to Step 3 above, start and stop the crusher 2 – 5 times to remove the difference in tension between the top and bottom, then check the tension accord- ing to Step 5 above. Check and adjustment of snaky movement of conveyor belt k If it becomes necessary to work on the adjust bolts, start with the work only after stopping the engine. If the belt starts snaking, turn adjustment bolt (1) to adjust the left and right tension. When turning the adjustment bolt, remove the stop- per plate to adjust, and after adjustment, install it to its original position without fail. 38 BR380JG-1E0