30 Testing and adjusting SEN02305-01 4. Loosen bolts (2), then rotate the cleaner plate as shown in the diagram. 7. Rotate cleaner shaft (8) so that cleaner plate (4) is at right angles. 5. Raise the cleaner 5 mm. 8. Check that cleaner tip (7) and the belt are at the 60° position, then tighten bolt (2) and nut (1). If the angle of the tip of the cleaner and the belt is less than 60°, move the cleaner up. 3 Bolt M12: 34.3 Nm {3.5 kgm} 6. Tighten nuts (5) and (6). BR380JG-1E0 41