Kaiyi BR380JG-1E0 — INSPECTION AND MAINTENANCE OF MAGNETIC SEPARATOR

SEN02305-01 30 Testing and adjusting Inspection and maintenance of magnetic separator The discharging belt for this machine has the same structure as that for the conventional belt conveyor. Pay attention to the following points, when starting the day's work or daily inspection. k There is danger that the magnetic field may cause malfunction of pacemakers, so per- sons wearing pacemakers should not approach within a range of 5 m from the magnetic separator. q Has the belt been biased or does it make a snaky movement? q Is the belt tension appropriate?

k The magnetic force will attract metal tools and pieces of steel, and there is danger of getting your fingers or hands caught between such objects and the attracting surface, so do not approach the magnetic separator when carrying metal tools or pieces of steel. q Are debris stuck to the backside of the belt? q Has the belt surface been scratched or peeled off? q Has the belt scraper not been damaged? q Have metal parts or bolts at the connection of the belt end not been damaged or fallen off? k Use a steel object removal belt to remove any pieces of steel attracted to the mag- netic separator. There is danger of injury, so do not approach the magnetic separator while it is being operated.

If anything unusual is found, take the following actions. 1) In case the belt is deflected or makes a snaky movement; Adjust the position of the take-up unit, referring to the figure. The take-up unit consists of a base plate, a pillow block and a tap bolt. Loosen the lock bolt on the base plate and adjust the position of the take-up unit with the tap bolt. After the adjustment, tighten the lock bolt again. When there is a clearance more than 10 mm at both ends from the inner surface of the flange at the end of the pulley, the belt is at a proper position. k When storing this machine or removing the magnetic separator, set up cones and make a no entry area.

Do not allow any person wearing a pacemaker to approach within a range of 5 m from the magnetic separator. k Before starting operations, check that there is no misalignment or snaking of the belt. k If there is any misalignment or snaking of the belt, there is danger that the belt will be damaged or cut. k There is danger of the magnetic field caus- ing damage, so do not bring watches, cellu- lar phones, or other precision instruments close to the magnetic separator. k There is danger of the stored data being damaged by the magnetic field, so do not carry bank cards, credit cards, or other cards with magnetic strips when approach- ing the magnetic separator.

k When conduction a trial run of the machine, be sure to run the motor at low speed and check that the conveyor belt does not make a snaky movement. k If metal pieces are drawn by the magnetic separator, they will be ejected, accelerated by the metal piece discharging belt. As that poses a big danger, provide a safety cover at the discharging outlet to prevent the metal pieces from flying off. k Do not feed concrete debris containing reinforcing bars larger than 13 mm in diam- eter and longer than 600 mm, since they can damage the conveyor belt. 44 BR380JG-1E0