30 Testing and adjusting SEN02305-01 2) In case the belt tension is not appropriate; Adjust the belt tension in the same way as mentioned above. At that time, adjust the belt so that it will have a clearance of 30 to 40 mm from the lower surface of the mag- net on the main body. 3) In case debris are stuck at the backside of the belt; Remove them as soon as found, since they can cause a damage on the belt or the pulley. Adjusting clearance from conveyor The clearance between the surface of the conveyor belt and the magnet when the machine is shipped from the factory is approx.
350 mm at both (A) and (B) when the primary conveyor height is at the fixed position for crushing reinforced concrete. Change as necessary according to the crusher dis- charge clearance and condition. For details of the fixed position for crushing reinforced concrete, see “Preparations for primary conveyor in Operation and maintenance manual”. 4) If the belt or any related part is broken, replace it immediately. Front (P): Change position of magnetic separator chain (1) to adjust, and fit on magnetic separator frame hook (2). Rear (Q): Change position of magnetic separator bracket hole (5) and magnetic separator frame hole (4) to adjust, then secure with pin (3). BR380JG-1E0 45