SEN02091-00 40 Troubleshooting Failure code [7RFPKB] Short circuit in lock cylinder push relay 1 34 BR380JG-1E0 User code Failure code Trouble Short circuit in lock cylinder push relay (Work equipment and pump controller (work equipment control) system) — 7RFPKB Contents of trouble • When the lock cylinder push relay circuit is driven, ground short circuit is detected. Action of controller • Turns OFF the output to each solenoid of lock cylinder push and pull, even if the crusher clearance decrease switch is turned ON. • Even if cause of failure disappears, system does not reset itself until engine starting switch is turned OFF.
Problem that appears on machine • The lock cylinders are not pushed and the crusher clearance cannot be adjusted. • Horn sounds (three intermittent sounding) upon detecting a failure. Related information • The drive state (ON/OFF) of the lock cylinder push relay can be checked with the monitoring func- tion (Code: 25601, Relay Drive 0) • Since the controller detects a disconnection when the relay output is ON, turn the output ON for reproduction check after recovery. • The failure history is recorded.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective lock cylin- der push relay (Internal disconnection) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. R13 (male) Resistance Between (5) and (6) 100 – 500 z 2 Grounding fault in wir- ing harness (Contact with ground circuit) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between C03 (female) (27) – R13 (female) (5) and chassis ground Resistance Min.
1 Mz 3 Defective work equip- ment and pump controller aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. C03 (male) Resistance Between (27) and chassis ground 100 – 500 z