Kaiyi BR380JG-1E0 — FAILURE CODE [CA238] ABNORMAL POWER SOURCE FOR NE SPEED SENSOR

SEN02092-00 40 Troubleshooting Failure code [CA238] Abnormal power source for Ne speed sensor 1 Circuit diagram related to engine Ne speed sensor 38 BR380JG-1E0 User code Failure code Trouble Abnormal power source for Ne speed sensor (Engine controller system) E15 CA238 Contents of • trouble Low voltage was detected in power supply circuit of engine Ne speed sensor. Action of • controller Continues control with signal from engine Bkup speed sensor. Problem that • appears on • machine Engine does not start easily. Engine hunts. Related • information Method of reproducing failure code: Turn starting switch ON.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting Defective sensor or 1 wiring harness aDisconnect connector with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. Disconnect sensor and wiring harness at right in order and carry out operation to reproduce trouble. If “E” of failure code goes off when sensor or wiring har- ness is disconnected, that sensor or wiring harness is defective. Ne speed sensor CRANK SENSOR Engine wiring harness CE01 Defective wiring har- 2 ness connector Connecting parts between each sensor – engine wiring harness – engine controller may be defective.

Check them directly. • Looseness of connector, breakage of lock, or breakage of seal • Corrosion, bend, breakage, push-in, or expansion of pin • Moisture or dirt in connector or defective insulation