Kaiyi BR380JG-1E0 — FAILURE CODE [CA272] DISCONNECTION IN FUEL PUMP ACTUATOR

SEN02092-00 40 Troubleshooting Failure code [CA272] Disconnection in fuel pump actuator 1 Circuit diagram related to supply pump actuator (metering unit) 40 BR380JG-1E0 User code Failure code Trouble Disconnection in fuel pump actuator (Engine controller system) E10 CA272 Contents of • trouble Opening was detected in drive circuit of supply pump actuator. Action of • controller None in particular. Problem that • appears on • machine Engine runs but its operation is unstable. Common rail fuel pressure rises above command value. Related • information Method of reproducing failure code: Turn starting switch ON.

1 2 Possible causes 3 and standard value in normal state 4 5 6 Cause Standard value in normal state/Remarks on troubleshooting Defective supply pump actuator aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. CP3 PUMP REGULATOR (male) Resistance Between (1) – (2) Max. 5 z Disconnection in wir- ing harness (Discon- nection in wiring or defective contact in connector) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE01 (female) (2) – CP3 PUMP REGULATOR (female) (1) Resistance Ma x.

10 z Wiring harness between CE01 (female) (32) – CP3 PUMP REGULATOR (female) (2) Resistance Ma x. 10 z Hot short (Short circuit with 24V circuit) in wir- ing harness aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. Wiring harness between CE01 (female) (2) – CP3 PUMP REGULATOR (female) (1) Voltage M ax. 3 V Short circuit in wiring harness (with another wiring harness) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE01 (female) (2) – each of CE01 (female) pins (With all wiring har- ness connectors disconnected) Resistance Min.

100 kz Defective wiring har- ness connector Connecting parts between supply pump actuator – engine wiring harness – engine controller may be defective. Check them directly. • Looseness of connector, breakage of lock, or breakage of seal • Corrosion, bend, breakage, push-in, or expansion of pin • Moisture or dirt in connector or defective insulation Defective engine controller aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. CE01 (male) Resistance Between (2) – (32) Max. 5 z