SEN02094-00 40 Troubleshooting Failure code [DA25KP] Abnormality in pressure sensor power source 1 10 BR380JG-1E0 User code Failure code Trouble Abnormality in pressure sensor power source (Work equipment and pump controller (pump control) system) — DA25KP Contents of trouble • Voltage from the pressure sensor power supply circuit reads under 2.0 V or above 5.3 V. Action of controller • Turn the pressure sensor power supply OFF. • Even if cause of failure disappears, system does not reset itself until starting switch is turned OFF. Problem that appears on machine • Overload on work equipment may not be detected but relieved.
• Due to abnormal pump pressure, overheat prevention function does not work normally. • Horn sounds (three intermittent sounding) upon detecting a failure. Related information • Method of reproducing failure code: Turn the starting switch ON. • The failure history is recorded. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective pressure sensor or potentiome- ter (Internal short cir- cuit) Disconnect devices listed at right sequen- tially and reproduce the failure. If E-mark of fail- ure code goes off, the device is defective internally.
Primary conveyor pressure sensor S01 Muck discharge conveyor pressure sensor S02 Magnetic separator pressure sensor S03 F pump pressure sensor S10 R pump pressure sensor S11 Clearance detection potentiometer S12 Secondary conveyor pressure sensor S06 Vibrating sieve pressure sensor S07 2 Ground fault in wiring harness (Contact with ground circuit) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between C01 (female) (22) – J03 – S01 (female) (3) and chassis ground [Primary conveyor pressure sensor system] Resistance Min.
1 Mz Wiring harness between C01 (female) (22) – J03 – S02 (female) (3) and chassis ground [Muck discharge conveyor pressure sensor sys- tem] Resistance Min. 1 Mz Wiring harness between C01 (female) (22) – J03 – S03 (female) (3) and chassis ground [Magnetic separator pressure sensor system] Resistance Min. 1 Mz Wiring harness between C01 (female) (22) – J03 – S10 (female) (3) and chassis ground [F pump pressure sensor system] Resistance Min. 1 Mz Wiring harness between C01 (female) (22) – J03 – S11 (female) (3) and chassis ground [R pump pressure sensor system] Resistance Min.
1 Mz Wiring harness between C01 (female) (22) – J03 – S12 (female) (C) and chassis ground [Clearance detection potentiometer system] Resistance Min. 1 Mz Wiring harness between C01 (female) (22) – J06 – S06 (female) (3) and chassis ground [Secondary conveyor pressure sensor system] Resistance Min. 1 Mz Wiring harness between C01 (female) (22) – J06 – S07 (female) (3) and chassis ground [Vibratory pressure sensor system] Resistance Min. 1 Mz