Kaiyi BR380JG-1E0 — INFORMATION IN TROUBLESHOOTING TABLE

40 Troubleshooting SEN02095-00 Information in troubleshooting table 1 a The following information is summarized in the troubleshooting table and the related electrical circuit diagram. Before carrying out troubleshooting, understand that information fully. Related circuit diagram This drawing is a part of the circuit diagram related to troubleshooting. Connector No.: Indicates (Model – Number of pins) and (Color). “Connector No. and pin No.” from each branching/merging point: Shows the ends of branch or source of merging within the parts of the same wiring harness. Arrow ( ): Roughly shows the location on the machine.

BR380JG-1E0 3 Trouble Trouble which occurred in the machine Related information Information related to detected trouble or troubleshooting Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Possible causes of trouble (Given num- bers are reference numbers, which do not indicate priority) • Standard value in normal state to judge possible causes • Remarks on judgment • Disconnection Connector is connected imperfectly or wiring harness is broken. • Ground fault Wiring harness which is not connected to chassis ground circuit is in contact with chassis ground circuit.

• Hot short Wiring harness which is not connected to power source (24 V) cir- cuit is in contact with power source (24 V) circuit. • Short circuit Independent wiring harnesses are in contact with each other abnormally. 1) Method of indicating connector No. and handling of T-adapter Insert or connect T-adapter as explained below for troubleshoot- ing, unless otherwise specified. • If connector No. has no marks of “male” and “female”, discon- nect connector and insert T-adapters in both male side and female side. • If connector No. has marks of “male” and “female”, disconnect connector and connect T-adapter to only male side or female side. 2) Entry order of pin Nos.

and handling of tester leads Connect positive (+) lead and negative (–) lead of tester as explained below for troubleshooting, unless otherwise specified. • Connect positive (+) lead to pin No. or wiring harness entered on front side. • Connect negative (–) lead to pin No. or harness entered on rear side. 2 3 4