Kaiyi BR380JG-1E0 — E-1 ENGINE DOES NOT START (ENGINE DOES NOT TURN)

SEN02095-00 40 Troubleshooting E-1 Engine does not start (Engine does not turn) 1 4 BR380JG-1E0 Trouble • Engine does not start (Engine does not turn). Related information • Engine starting circuit has following 2 start lock mechanisms. 1) Start lock with password of machine monitor Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Low charge level of battery aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Battery voltage (2 pieces) Electrolyte specific gravity (1 piece) Min. 24 V Min. 1.26 2 Defective fuse No.

1 or fusible link E02 If fuse or fusible link is broken, circuit probably has ground fault. (See cause 10.) 3 Defective starting switch (Internal discon- nection) aPrepare with starting switch OFF, then keep starting switch OFF and turn it to START and carry out troubleshooting in each case. H15 (male) Starting switch Resistance Between (1) – (4) OFF Min. 1 Mz START Max. 1 z 4 Defective starting motor cutout relay R01 (Internal disconnec- tion or short circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. R01 (male) Resistance Between (1) – (2) 250 – 350 z Between (3) – (5) Min. 1 Mz Between (3) – (6) Max.

1 z 5 Defective starting motor safety relay (Internal defect) aPrepare with starting switch OFF (with only terminal C disconnected), then turn starting switch to START and carry out troubleshooting. Safety relay terminal Voltage Between B – E Power supply 20 – 30 V Between R (E09-2) – E Generation input Max. 1 V Between S (E09-1) – E Starting input 20 – 30 V Between C (T04) – E Starting output 20 – 30 V If power supply, generation input, and starting input are normal but starting output is not normal, starting motor safety relay is defective. 6 Defective starting motor (Internal defect) aPrepare with starting switch OFF, then turn starting switch to START and carry out troubleshooting.

Starting motor terminals Voltage Between B (SB) – chas- sis ground Power supply 20 – 30 V Between C (SC) – chassis ground Starting input 20 – 30 V If power supply and starting input are normal but starting motor does not turn, starting motor is defective. 7 Defective alternator (Internal short circuit) aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Alternator Voltage Between L – chassis ground Generation output Max. 1 V