Kaiyi BR380JG-1E0 — E-3 THE AUTOMATIC WARM-UP FUNCTION DOES NOT WORK

SEN02095-00 40 Troubleshooting E-3 The automatic warm-up function does not work. 1 10 BR380JG-1E0 Trouble • The automatic warm-up function does not work. Related information • When the engine coolant temperature is below 30°C, the automatic warm-up device raise the engine speed to 1,200 rpm. • If the fuel control dial is opened more than 70% for 3 seconds when the starting switch is turned ON or after the engine is started, the automatic warm-up function is reset. • If engine coolant temperature is below 10°C, turbocharge protection function operates to keep the engine speed at low idle.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective engine cool- ant temperature signal If the monitor does not display normally, go to troubleshooting No. E-11. Monitoring code Monitoring item Normal display 04107 Engine coolant temperature Compare with actual engine coolant temper- ature. 2 Defective engine con- troller Troubleshooting cannot be carried out since the defect is in the controller. (If the above cause is not the cause of the failure, the engine controller must be defective.)