Kaiyi BR380JG-1E0 — E-14 THE TRAVEL, WORK, AND INSPECTION MODES DO NOT CHANGE

SEN02095-00 40 Troubleshooting E-14 The travel, work, and inspection modes do not change. 1 28 BR380JG-1E0 Trouble • When the mode selector switch is changed, the current mode does not change. Relative information • The mode selector switches (Mode selector work switch of switch input 2 and mode selector travel switch) can be checked in the monitoring function of the machine monitor. (Code 25002:

Mode selector switch, mode selector travel switch) Mode Mode selector working switch Mode selector travel switch Work ON OFF Travel ON ON Testing OFF OFF • Check if failure code for CAN communication error (machine monitor) system [DAFRMC] is indi- cated (if yes, diagnose that failure first.) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective mode selec- tor switch (Internal disconnection or short circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Selector switch B13 (male) Position of selector switch Resistance Between (2) – (4) Inspection Min.

1 Mz Between (3) – (4) Min. 1 Mz Between (2) – (4) Work Min. 1 Mz Between (3) – (4) Max. 1 z Between (2) – (4) Travel Max. 1 z Between (3) – (4) Max. 1 z 2 Defective fuse (10) If the fuse or block fuse is broken, the circuit probably has a grounding fault, etc. 3 Disconnection in wiring harness (Disconnection in wir- ing harness or defec- tive contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between fuse box B28 (12) – B13 (female) (4) Resistance Max. 1 z C01 (female) (5) – B13 (female) (2) Resistance Max. 1 z C01 (female) (11) – B13 (female) (3) Resistance Max.

1 z 4 Hot short in wiring har- ness (Contact with ground circuit) aPrepare with starting switch OFF, then turn starting switch ON and turn selector switch to Inspection and carry out troubleshooting. Wiring harness between C01 (female) (5) – B13 (female) (2) and chassis ground Voltage Max. 1 V Wiring harness between C01 (female) (11) – B13 (female) (3) and chassis ground Voltage Max. 1 V 5 Grounding fault in wir- ing harness (Short circuit with GND circuit) aPrepare with starting switch OFF, then turn starting switch ON and turn selector switch to Travel and carry out troubleshooting.

Wiring harness between C01 (female) (5) – B13 (female) (2) and chassis ground Voltage 20 – 30 V Wiring harness between C01 (female) (11) – B13 (female) (3) and chassis ground Voltage 20 – 30 V