Kaiyi BR380JG-1E0 — E-19 THE FEEDER CANNOT BE TURNED ON AND OFF BY RADIO CONTROL

SEN02095-00 40 Troubleshooting E-19 The feeder cannot be turned ON and OFF by radio control 1 40 BR380JG-1E0 Trouble • The feeder cannot be turned ON and OFF by radio control. Relative information • Radio control system is an optional specification. • (1) Start the engine and turn the radio control selector switch to the remote control position, (2) Turn the power switch of the radio control transmitter ON, and (3) Check that the radio wave from the radio control transmitter is received by the receiver (The antenna of the receiver is built in). If the radio wave is received, the yellow radio control lamp lights up and the machine can be radio- controlled.

• If the mode selector switch is set in the WORK position under the above condition, the feeder can be operated. • The machine does not work on the conveyor up position. • The feeder works when the feeder ON switch is pressed within about 30 seconds after the working mode selector switch of radio controller is pressed. • It is not necessary to press the selector switch beforehand when the feeder OFF switch is being pressed. • If any of (1), (2), and (3) above is not established (If the radio control lamp does not light up), the machine cannot be radio-controlled.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective fuse No. 13 If the fuse is broken, the circuit probably has a grounding fault. 2 Defective radio control power supply circuit (Disconnection or short circuit) aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Receiver connector A33 (female) Radio control selector switch Voltage Between (1) – (2) Panel Max. 1 V Remote control 20 – 30 V If the above power supply circuit is found to be defective, carry out troubleshooting for 2-1 to 2-4 below.

2-1 Defective radio controller selec- tor switch (Inter- nal disconnection or short circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Radio controller selec- tor switch B50 (male) Radio controller selec- tor switch Resistance (2) – (4) Panel Min. 1 Mz Remote control Max. 1 z 2-2 Disconnection in wiring harness (Disconnection or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Between B28 (13) – A20 (1) – A44 (1) – A33 (female) (1) Resistance Max. 1 z Between B50 (female) (2) – A20 (2) – A44 (2) – A33 (female) (2) Resistance Max.

1 z 2-3 Grounding fault in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Between wiring harness B28 (13) – A20 (1) – A44 (1) – A33 (female) (1) and chassis ground Resistance Min. 1 Mz Between wiring harness A33 (female) (16) – RR04 (female) (2) and chassis ground Resistance Min. 1 Mz 2-4 Hot short circuit in wiring harness (Contact with 24V circuit) (Troubleshooting with radio control- ler selector switch turns to Panel.) aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting.

Between wiring harness B50 (female) (2) – A20 (2) – A44 (2) – A33 (female) (2) and chassis ground Voltage Max. 1 V