Kaiyi BR380JG-1E0 — E-19 THE FEEDER CANNOT BE TURNED ON AND OFF BY RADIO CONTROL

40 Troubleshooting SEN02095-00 BR380JG-1E0 41 Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 3 Disconnection in wiring harness (Disconnection in wir- ing harness or defec- tive contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between A33 (female) (3) – A45 – A32 (female) (1) Resistance Max. 1 z Wiring harness between A33 (female) (3) – chas- sis ground Resistance Max. 1 z Wiring harness between A33 (female) (10) – A44 (3) – A20 (3) – C03 (female) (10) Resistance Max.

1 z Wiring harness between A33 (female) (13) – RR01 (female) (2) Resistance Max. 1 z Wiring harness between A33 (female) (1) – RR01 (female) (1), and RR04 (female) (1) Resistance Max. 1 z Wiring harness between RR01 (female) (6) – A44 (5) – A20 (5) – C03 (female) (20) Resistance Max. 1 z Wiring harness between RR01 (female) (3) – chassis ground Resistance Max. 1 z Wiring harness between A33 (female) (12) – A44 (10) – A20 (10) – C03 (female) (19) Resistance Max. 1 z Wiring harness between B50 (female) (2) – C03 (female) (39) Resistance Max. 1 z Wiring harness between A33 (female) (16) – RR04 (female) (2) Resistance Max.

1 z 4 Defective relay (Internal disconnection or short circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. RR01 (male) Resistance Between (1) – (2) 250 – 350 z Between (3) – (6) Max. 1 z 5 When controller detects failure of related section If any of the following errors is displayed in the electrical system errors on the monitor, see the troubleshooting for it.

• Short circuit in feeder-ON switch [7RC5KB] • Disconnection in grizzly feeder stop switch [7REPKA] • Disconnection in feeder forward EPC solenoid [7RF4KA] • Short circuit in feeder forward EPC solenoid [7RF4KB], [7RF4KY] 6 Defective transmitter or receiver If all the results of above checks 1 – 5 are normal, the transmitter or receiver is defective.