Kaiyi BR380JG-1E0 — H-2 THE ENGINE SPEED LOWERS EXTREMELY OR THE ENGINE STALLS

SEN02306-01 40 Troubleshooting H-2 The engine speed lowers extremely or the engine stalls 1 Note 1: Disconnect the hydraulic hose and piping (travel main circuit) and install adapters to block the ends. 10 BR380JG-1E0 Trouble • The engine speed lowers extremely or the engine stalls. Relative information • Carry out troubleshooting in the WORK or TRAVEL mode. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective adjustment or malfunction of main relief valve aPrepare with engine stopped, then run engine at high idle and carry out troubleshooting. Measurement condition Main relief pressure Relieve travel circuit (Note 1).

+1.0 39.2 MPa –2.5 +10 {400 kg/cm2} –25 If the oil pressure does not become normal after adjustment, the main relief valve may have a malfunction or a defect in it. Check the main relief valve directly. 2 Defective adjustment or malfunction of PC valve aPrepare with engine stopped, then run engine at high idle and carry out troubleshooting. Oil pressure to be measured Measurement condition Ratio of oil pressure Pump discharge pressure Relieve travel circuit (Note 1). 1 PC valve output pressure Approx. 3/5 If the oil pressure does not become normal after adjustment, the PC valve may have a malfunction or a defect in it. Check the PC valve directly.

3 Defective adjustment or malfunction of LS valve aPrepare with engine stopped, then run engine at high idle and carry out troubleshooting. Oil pressure to be measured Ratio of oil pressure Turn all work equipment switches OFF Turn all work equipment switches ON (with no load) Pump discharge pressure Almost same 1 LS valve output pressure Approx. 3/5 If the oil pressure does not become normal after adjustment, the LS valve may have a malfunction or a defect in it. Check the LS valve directly. 4 Clogging of orifice or fil- ter in servo equipment An orifice or a filter in the pump servo equipment may be clogged. Check them directly.

5 Malfunction of servo piston The servo piston may have malfunction. Check it directly.