Kaiyi BR380JG-1E0 — H-17 THE MACHINE DEVIATES DURING TRAVE

40 Troubleshooting SEN02306-01 H-17 The machine deviates during travel 1 BR380JG-1E0 21 Trouble • The machine deviates during travel. Relative information • Before carrying out the troubleshooting, set the mode selector switch in the TRAVEL mode. • Set the conveyor to up position (travel position) and carry out troubleshooting. • Set the travel speed selector switch at high-speed and carry out troubleshooting. • Carry out the following troubleshooting when the work equipment speed is normal.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Malfunction of travel PPC valve aPrepare with engine stopped, then run engine at high idle and carry out troubleshooting. Travel lever PPC valve output pressure FORWARD or REVERSE Min. 2.5 MPa {Min. 26 kg/cm2} Output difference between forward and lateral directions Max. 0.39 MPa {Max. 4 kg/cm2} 2 Malfunction of self- reducing pressure valve aPrepare with engine stopped, then run engine at high idle and carry out troubleshooting.

Travel lever Control circuit basic pressure All levers in neutral 2.84 – 3.43 MPa {29 – 35 kg/cm2} 3 Defective adjustment or malfunction of LS valve aPrepare with engine stopped, then run engine at high idle and carry out troubleshooting. aSet the mode selector switch in the WORK mode and carry out trouble- shooting. Oil pressure to be measured Ratio of oil pressure Turn all work equipment switches OFF Turn all work equipment switches ON (with no load) Pump discharge pressure Almost same 1 LS valve output pres- sure Approx. 3/5 4 Malfunction of travel junction solenoid valve aPrepare with engine stopped, then run engine at high idle and carry out troubleshooting.

Travel lever Solenoid output pressure Both sides are operated or neutral 0 MPa {0 kg/cm2} Operate one side 2.84 – 3.43 MPa {29 – 35 kg/cm2} 5 Malfunction of shuttle valve The shuttle valve may have a malfunction. Check it directly. (When radio control specification is installed) 6 Malfunction of travel junction valve The travel junction valve may have a malfunction. Check it directly. 7 Malfunction of travel control valve (spool) The travel control valve spool may have a malfunction. Check it directly. 8 Defective travel motor aPrepare with engine stopped, then run engine at high idle and carry out troubleshooting. Travel lever Main relief pressure Relieve travel circuit.

(Note 1) +1.0 39.2 MPa –2.5 +10 {400 kg/cm2} –25