SEN02307-00 40 Troubleshooting S-1 Starting performance is poor 1 *1: Displayed failure codes [CA559] and [CA2249] 6 BR380JG-1E0 General causes why starting performance is poor q Defective electrical system q Insufficient supply of fuel q Insufficient intake of air q Improper selection of fuel a The common rail fuel injection system (CRI) recognizes the fuel injection timing electrically. Accordingly, even if the starting operation is carried out, the engine may not start until the crankshaft revolves 2 turns at maximum. This phe- nomenon does not indicate a trouble, however.
Causes Clogged air cleaner element Defective contact of valve, vale seat Worn piston ring, cylinder Clogged air breather hole of fuel tank cap Leaking or clogged fuel piping, entry of air Clogged fuel filter, element Stuck, seized supply pump plunger Defective injector Defective intake air heater system Defective alternator (regulator section) Defective alternator (generator section) Defective, deteriorated battery Questions Check items Confirm recent repair history Degree of use of machine Operated for long period E E E Starting performance Became worse gradually Q w w Q Engine starts easily when warm w w Non-specified fuel is being used Q Q Q Replacement of filters has not been carried out according to Operation and Mainte- nance Manual w w Q Q Engine oil must be added more frequently w When engine is preheated or when temperature is low, preheating monitor does not indicate normally w During operation, charge level monitor indicates abnormal charge w w Dust indicator is red w Air breather hole of fuel tank cap is clogged w Fuel is leaking from fuel piping w Q When priming pump is operated, it makes no reaction or it is heavy w Q Starting motor cranks engine slowly w While engine is cranked with starting motor If air bleeding plug of fuel filter is removed, fuel does not flow out w There are a lot of return rates from injector w When exhaust manifold is touched immediately after starting engine, temperature of some cylinders is low w Engine does not pick up smoothly and combustion is irregular Q Q w There is hunting from engine (rotation is irregular) Q w Q Blow-by gas is excessive w Troubleshooting Inspect air cleaner directly q When compression pressure is measured, it is found to be low q q When air is bled from fuel system, air comes out q Inspect fuel filter, strainer directly q Carry out troubleshooting according to “Rail Press (Very) Low Error (*1)” indicated by code q When a cylinder is cut out for reduced cylinder mode operation, engine speed does not change q When starting switch is turned to HEAT, intake air heater mount does not become warm q Is voltage 20 – 30 V between alternator terminal B and terminal E with engine at low idle?
Yes q No q When specific gravity of electrolyte and voltage of battery are measured, they are low q Remedy Clean Replace Replace Clean correct Clean Replace Replace Replace Adjust Replace Replace