40 Troubleshooting SEN02307-00 S-14 Coolant temperature becomes too high (overheating) 1 BR380JG-1E0 21 General causes why coolant temperature becomes too high q Lack of cooling air (deformation, damage of fan) q Drop in heat dissipation efficiency q Problem in coolant circulation system q Rise in hydraulic oil temperature o Carry out troubleshooting for machine Causes Broken cylinder head, head gasket Holes caused by pitting Clogged, broken oil cooler Lack of coolant Broken water pump Defective operation of thermostat Clogged, crushed radiator fins Clogged radiator core Defective radiator cap (pressure valve) Defective fan pulley bearing Slipping fan belt, worn fan pulley Defective coolant temperature gauge Rise of hydraulic oil temperature on applicable machine side Questions Check items Confirm recent repair history Degree of use of machine Operated for long period E E E E Condition of overheating Sudden overheated Q w Q Always tends to overheat Q w w Q Coolant temperature gauge (if installed) Rises quickly Q w Does not go down from red range w Radiator coolant level monitor indicates drop of coolant level (if monitor is installed) w Engine oil level has risen and oil is milky w Q Fan belt tension is low w When fan belt is turned, it has play w Milky oil is floating on coolant w There are excessive air bubbles in radiator, coolant spurts back w When light bulb is held behind radiator core, no light passes through w Radiator shroud, inside of underguard on applicable machine side are clogged with dirt or mud w w Coolant is leaking because of cracks in hose or loose clamps w Coolant flows out from radiator overflow hose w Fan belt whines under sudden acceleration w Hydraulic oil temperature enters red range faster than engine coolant temperature w Troubleshooting When compression pressure is measured, it is found to be low q Carry out troubleshooting on applicable machine side Inspect cylinder bore directly q Inspect oil cooler directly q Temperature difference between upper and lower tanks of radiator is large q When operation of thermostat is carried out, it does not open at cracking temperature q Temperature difference between upper and lower tanks of radiator is slight q Inspect radiator core directly q When operation of radiator cap is carried out, its cracking pressure is low q Inspect fan belt, pulley directly q When coolant temperature is measured, it is fount to be normal q Remedy Replace Replace Replace Add Replace Replace Correct Correct Replace Replace Correct Replace —