SEN02307-00 40 Troubleshooting S-15 Abnormal noise is made 1 22 BR380JG-1E0 General causes why abnormal noise is made q Abnormality due to defective parts q Abnormal combustion q Air sucked in from intake system a Judge if the noise is an internal noise or an external noise before starting troubleshooting. a The engine is operated in the low-temperature mode while it is not warmed up sufficiently. Accordingly, the engine sound becomes a little larger. This does not indi- cate abnormality, however. a When the engine is accelerated, it is operated in the acceleration mode and its sound becomes a little larger for up to about 3 seconds. This does not indicate abnor- mality, however.
Causes Leakage of air between turbocharger and cylinder head Interference of turbocharger, seized turbocharger Broken dynamic valve system (valve, rocker lever) Defective inside of muffler (dividing board out of position) Improper valve clearance Excessive wear of piston ring, cylinder liner Improper gear train backlash Removed, seized bushing Deformed cooling fan, loose fan belt, interference of fan belt Clogged, seized injector Dirt caught in injector Improper fuel injection timing (abnormality in coolant low temperature sensor, boost temperature sensor) Questions Check items Confirm recent repair history Degree of use of machine Operated for long period E Condition of abnormal noise Gradually occurred Q Q Sudden occurred Q Q Q Non-specified fuel is being used Q Oil must be added more frequently w Metal particles are found when oil filter is drained w w Air leaks between turbocharger and cylinder head w When engine is cranked, interference sound is generated around turbocharger w When engine is cranked, abnormal sound is generated around cylinder head w w When engine is cranked, beat noise is generated around muffler w When exhaust manifold is touched immediately after starting engine, temperature of some cylinders is low w Q Color of exhaust gas Blue under light load w Black Q w Q Engine does not pick up smoothly and combustion is irregular w Abnormal noise is loud when engine is accelerated Q Q Q Q Blow-by gas is excessive w Troubleshooting When turbocharger is rotated by hand, it is fount to be heavy q Inspect dynamic valve system directly q When muffler is removed, abnormal noise disappears q Inspect valve clearance directly q When compression pressure is measured, it is found to be low q Inspect gear train directly q q Inspect fan and fan belt directly q When a cylinder is cut out for reduced cylinder mode operation, engine speed does not change q q Abnormal noise is heard only when engine is started q Confirm with INSITE or monitoring function on applicable machine side q Remedy Replace Replace Correct Replace Adjust Replace Replace Replace Correct Replace Replace Replace