50 Disassembly and assembly SEN02738-00 2. Installation of clevis and flange 1) Install seals (4), (5), (6), and (7). a Take care not to mistake the positions of the seal and ring or the direction of the lip. a If there is rust or a flaw on the fitting part, remove it. Assembly 1. Assembly of clevis 1) Clean the part to fit bushing (12). 2 Fitting part: Anti-seizure compound (Molybdenum spray, etc.) 2) Using tool (11) and a hammer, press fit bushing (12). a Adjusting the center of the bushing, press fit the bushing slowly. 2) Install flange (2) with the hook spanner. 2 Fitting part: Same oil as currently applied one, grease, etc. (Apply thinly) 2 Threaded part:
Anti-seizure compound (Molybdenum spray, etc.) a Tighten the flange slowly so that it will not be seized. a Retighten the flange by using a hammer. 3 Flange: 980 Nm {100 kgm} 3) Install ring (10) with snap ring pliers. BR380JG-1E0 13