10 Structure, function and maintenance standard SEN01351-00 Function q Rocker cam (4) conducts high pressure oil to the cylinder surface (B) with cradle (2), which is secured to the case, and forms a static pres- sure bearing when it slides. q The pump converts the engine rotation and torque transmitted to its shaft to oil pressure and delivers pressurized oil corresponding to the load. q Piston (6) carries out relative movement in the axial direction inside each cylinder chamber of cylinder block (7). q It is possible to change the discharge amount by changing the swash plate angle. q Cylinder block (7) seals the pressurized oil to valve plate (8) and carries out relative rotation.
Structure q This surface is designed so that the oil pres- sure balance is maintained at a suitable level. q Cylinder block (7) is supported to shaft (1) by spline (14). q Shaft (1) is supported by front and rear bear- ings (15). q The oil inside the respective cylinder chambers of cylinder block (7) is suctioned and dis- charged through valve plate (8). q Tip of piston (6) is shaped as a concave ball and shoe (5) is caulked to it to form one unit. q Piston (6) and shoe (5) constitute the spherical bearing. q Rocker cam (4) has flat surface (A), and shoe (5) is always pressed against this surface while sliding in a circular movement. BR380JG-1E0 7