359 To move the text cursor to the centre of the screen in MODE 7 one would execute the statement VDU 31,20,10 Note that the maximum values of X and Y depend on the MODE selected and that both X and Y are measured from the edges of the current text window not the edges of the screen. 32-126 These codes generate the full set of letters and numbers in the ASCII set. See the ASCII codes in the Appendices. 127 This code moves the text cursor back one character and deletes the character at that position. VDU127 has exactly the same effect as the DELETE key. 128-223 These characters are normally undefined and will produce random shapes (see below and chapter 43).
224-255 These characters may be defined by the user using the statement VDU23 . It is thus possible to have 32 user defined shapes such as … VDU 23,224,8,28,28,107,127,107,8,28 ‡ VDU 23,225,8,28,62,127,62,28,8,0 † VDU 23,226,54,127,127,127,62,28,8,0 „ VDU 23,227,8,28,62,127,127,127,28,62 Note: You can use a *FX command which will then allow you to define characters 128 to 159 rather than 224 to 255. This has the advantage that you will then be able to use the new characters easily by holding down the SHIFT key while pressing one of the user definable (red) keys (see chapter 43).