403 *FX9 and *FX10 are used to set the flash rate of flashing colours. Colours always flash between one colour and its complement. Thus in MODE 2 , COLOUR 9 selects flashing red/cyan.(See chapter 34 for more information on COLOUR .) *FX9 is followed by a number which gives the duration of the first named colour. The duration is given in fiftieths of a second. Thus to select one fifth of a second one would use the statement *FX9,10 The default is *FX9,25 *FX10 is used to set the period of the second named colour. See the entry above for *FX9 . Note that values of 0 for the duration will eventually force the selected state to occur full time.
If neither counter is set to zero then setting the other counter to zero will immediately force the latter colour to appear. The default is *FX10,25 . *FX11 If a key is held depressed then after a short delay (the auto-repeat delay) the key will repeat automatically every so often. The delay is given in hundredths of a second. *FX11 sets the delay before the auto-repeat starts. *FX11,0 turns off the auto-repeat all together. *FX11,5 would set the auto-repeat delay to five hundredths of a second, etc. *FX12 sets the auto-repeat period, that is the amount of time between the generation of each character. *FX12,0 resets both the auto-repeat delay and the auto-repeat to their normal values.
*FX12,10 would set the auto-repeat period to ten hundredths of a second thus producing ten characters per second. *FX13 and *FX14 are used to disable and enable certain events. These *FX calls will only be used by programmers writing in Assembly Language and more information on events is given in chapter 44. The summary which follows should be read in conjunction with that chapter. *FX13,0 disables output buffer empty event. *FX13,1 disables input buffer full event. *FX13,2 disables character entering input buffer event. *FX13,3 disables ADC conversion complete event.