Acorn Computers BBC Micro Model B w/8271 — Acorn BBC Micro Model B w/8271 User Guide Manual PDF

409 Bit 4 set – Disables spooled output. Bit 5 – Not used. Bit 6 set – Disables printer driver unless the output character is preceded by a VDU1 command (or equivalent). Bit 7 – Not used. The default options (X=0) are: RS423 disabled VDU enabled Printer enabled (if selected by VDU2 ) Spooled output enabled (if selected by *SPOOL ) This OSBYTE call uses OSBYTE with A=&EC (236). On exit, A is preserved, X contains the previous *FX3 status, Y and C are undefined. OSBYTE call with with A=&4 (4) Enable/disable cursor editing keys X=0 Cursor editing enabled (default setting). X=1 Cursor editing disabled.

The cursor control keys will return normal ASCII codes, see *FX4,1 (later in this chapter) for details. X=2 Cursor editing disabled. The cursor control keys act as soft keys with soft key association numbers as detailed under *FX4,2 (see later in this chapter). On exit, A is preserved, X contains the previous *FX4 setting, Y and C are undefined. On entry, the value in X determines the editing keys’ status, as follows: OSBYTE call with A=&5 (5) Select printer type/output channel On entry, the value in X determines the print destination, as follows: X=0 Printer sink (printer output ignored). X=1 Parallel printer (default setting). X=2 Serial printer (RS423 output).

This setting will produce the effect of a printer sink if the RS423 is enabled using OSBYTE with A=3. X=3 User supplied printer driver routine, the address of which should be placed starting at location &222. X=4 Econet printer. X=5-255 User supplied printer driver routine (see X=3 above). On exit, A is preserved, X contains the previous *FX5 setting, Y and C are undefined. This call enables interrupts, and is not reset to default by a soft break.