412 OSBYTE call with A=&11 (17) Force ADC conversion on specified channel On entry, X contains the required channel number. If X>4 then X is reset to 4. See also OSBYTE with A=&80 (128). On exit, A is preserved, X is preserved unless it is greater than 4 – in which case X is reset to 4, Y and C are undefined. OSBYTE call with A=&12 (18) Reset soft keys This call resets the user-defined function keys so that they no longer contain character strings. There are no entry conditions. On exit, A and Y are preserved, X and C are undefined. OSBYTE call with A=&13 (19) Wait for field synchronisation This call causes the machine to wait until the start of the next frame of the display.
This occurs 50 times per second and can be used for timing or animation. User trapping of IRQ1 (see chapter 44) may stop this call from working. There are no entry conditions. On exit, A and Y are preserved, X and C are undefined. OSBYTE call with A=&14 (20) Explode soft character RAM allocation This call assigns memory blocks for use by soft character defenitions. On entry, the value in X determines the memory block(s) to be assigned, corresponding to n for the *FX20, n commands (see later in this chapter). See also OSBYTE call with A=&B6 (182). On exit, A is preserved, X contains the new OSHWM (high byte), Y and C are undefined.
OSBYTE call with A=&15 (21) Flush specified buffer On entry, the value in X determines the buffer to be flushed, corresponding to n for the *FX21, n commands (see later in this chapter). See also OSBYTE calls with A=&0F (15) and &80 128). On exit, A and X are preserved, Y and C are undefined. OSBYTE call with A=&72 (114) Control shadow/main memory selection On entry, X=0 selects the shadow display RAM, X=1 selects the main display RAM. Note that the value of HIMEM is not reset by this command. On exit, X contains the previous display memory selection, A is preserved, Y and C are undefined. (See chapter 42 for details of the shadow screen facility).