Overview of NC Errors NC Errorcodes 22 Version: 1.1 Error(Hex) Error(Dec) Error type Description MODULO (5), , etc. Furthermore, it is possible that the types for setting a new actual position or moving to a new end position are invalid. 4251 16977 Function Function is not supported An NC function has been activated that is currently not released for use, or which is not even implemented. This can be a command which is not possible or not allowed for master axes. 4252 16978 Monitoring State of state machine invalid (internal error) The state for one of the internal state machines is invalid. This is an internal error.
4253 16979 Monitoring PLC reference cam became free too soon During the referencing process for an axis it is moved in the direction of the PLC referencing cam, and is only stopped again when the cam signal is reached. After the axis has then also physically stopped, the referencing cam must remain occupied until the axis subsequently starts back down from the cam in the normal way.
4254 16980 Monitoring Distance monitoring between activation of the hardware latch and appearance of the I/O sync pulse When the distance monitoring is active, a check is kept on whether the number of increments between activation of the hardware latch and occurrence of the sync pulse (zero pulse) has become smaller than a pre-set value. If this case has occurred, this error will be generated. (see parameters for the incremental encoder) 4255 16981 Memory No memory available The dynamic memory allocation for the setpoint generator, the SPP table or the SEC table has failed.
4256 16982 Monitoring The table slave axis has no active table Although the table slave axis has tables, none of the tables is designated as active. If this occurs during the runtime the whole master/slave group is stopped by a runtime error. 4257 16983 Function Function not allowed The requested function or the requested task is not logically allowed. An example for such an error message would be "set an actual position" for an absolute encoder (M3000, KL5001, etc.). 4258 16984 Function Stopping compensation not allowed It is not possible to stop the compensation, since compensation is already in the stopping phase.
4259 16985 Function Slave table is being used The slave table cannot be activated, because it is currently being used. 425A 16986 Function Master or slave axis is processing a job (e.g. positioning command) while coupling is requested A master/slave coupling of a certain slave type (e.g. linear coupling) cannot be executed, because either the master axis or the future slave axis is not at standstill, but executes a job (e.g. a positioning) at the coupling time. For this couple type this is not allowed. 425B 16987 Parameter Slave (start) parameter is incorrect