Overview of NC Errors NC Errorcodes 24 Version: 1.1 Error(Hex) Error(Dec) Error type Description 4267 16999 Function Group function for slave not allowed Group functions are in principle only possible for master axes, not for slave axes. The only exception is represented by the "Start/stop section compensation" function, which is possible both for masters and for slaves. A slave cannot directly execute any other functions beyond this. 4268 17000 Function NCI setpoint generator is inactive An NCI command such as "StopAndKeep" is sent to a logically inactive DXD group or to a group with the channel override state zero.
However, it is expected that the NCI group is actively in setpoint generation for the implementation of this command. This error can occur in connection with the functions "delete distance to go" and "measurement event (latch actual position)". 4269 17001 Parameter Start position = target position Invalid position parameters. 426A 17002 Parameter Parameters of the delay-generator are invalid Invalid external/internal parameters of the delay generator (delay time, cycle time, tics). 426B 17003 Parameter External parameters of the compensation are invalid Invalid external parameters of the superimposed functionality (acceleration, deceleration, velocity, process velocity, length).
426C 17004 Parameter Invalid override type The selected override type is invalid. 426D 17005 Function Activation position under/overrun The requested activation position is located in the past of the master (e.g. when exchanging a cam plate). 426E 17006 Function Activation impossible: Master at standstill The required activation of the correction is impossible since the master axis is not moving. An accurate synchronization is not possible, because the master axis is at standstill and the slave axis is not yet synchronized. 426F 17007 Function Activation mode not possible The requested activation mode is not possible when the slave axis is moving.
Otherwise the slave velocity would jump to zero. 4270 17008 Parameter Start parameter of the compensation invalid One of the dynamic parameters of the compensation is invalid (necessary condition): acceleration (>0) deceleration (>0) process velocity (>0) 4271 17009 Parameter Start parameter of the compensation invalid Velocity overshoot is negative. 4272 17010 Parameter Start parameter of the compensation invalid The section on which the compensation is to occur is not positive. 4273 17011 Monitoring Target position under/overrun" (internal error) The position (calculated from the modulo target position) where the axis should stand at end of oriented stop has been run over.
4274 17012 Monitoring Target position will be under/overrun (internal error)