Overview of NC Errors NC Errorcodes 41 Version: 1.1 Error(Hex) Error(Dec) Error type Description 433A 17210 Parameter Parameter "Fading Acceleration" is invalid The Fading Acceleration parameter for the fading profile from SET to ACTUAL values is invalid. This parameter defines how to fade from a setpoint based axis coupling to an actual value based coupling (indirectly results in a time for the fading). The value 0.0 causes the minimum of the default acceleration and default deceleration to be used internally in the NC as the fading acceleration. Value range: [0; 0.01 .. 1.0e+20] Unit: e.g.
mm/s^2 Error(Hex) Error(Dec) Error type Description 433B 17211 Parameter Fast Axis Stop signal type not allowed The value for the Signal Type of the 'Fast Axis Stop' is not allowed [0...5]. 433C 17212 Parameter ADS index offset not allowed New value for the 'ADS offset (axis state) ' for user- defined parameter named 'UserData' in AxisRef is invalid. 4340 17216 Initialization Axis initialization The axis has not been initialized. Although the axis has been created, the rest of the initialization has not been performed (1. Initialization of axis I/O, 2. Initialization of axis, 3. Reset axis).
4341 17217 Address Group address The axis does not have a group, or the group address has not been initialized (group contains the setpoint generation). 4342 17218 Address Encoder address The axis does not have an encoder, or the encoder address has not been initialized. 4343 17219 Address Controller address The axis does not have a controller, or the controller address has not been initialized. 4344 17220 Address Drive address The axis does not have a drive, or the drive address has not been initialized. 4345 17221 Address Axis interface PLC to NC address The axis has no axis interface from the PLC to the NC (PlcToNc) or the axis interface address has not been initialized.
4346 17222 Address "Axis interface NC to PLC address The axis has no axis interface from the NC to the PLC (NcToPlc) or the axis interface address has not been initialized. 4347 17223 Address Size of the axis interface NC to PLC is not allowed (internal error) The size of the axis interface from NC to PLC (NcToPlc) is not allowed. 4348 17224 Address Size of the axis interface PLC to NC is not allowed (internal error) The size of the axis interface from PLC to NC (PlcToNc) is not allowed.