beckhoff TwinCAT 2 Motion — 2.7 Drive error

Overview of NC Errors NC Errorcodes 63 Version: 1.1 Error(Hex) Error(Dec) Error type Description 461C 17948 Parameter Drive filter type not allowed for command variable filter for the output position The value is impermissible as a drive filter type for the smoothing of the output position (command variable filter for the setpoint position). Value range: [0, 2] Unit: 1 461D 17949 Parameter Drive filter time not allowed for command variable filter for the output position The value is impermissible as a drive filter time for the smoothing of the output position (command variable filter for the setpoint position). Value range: [0.0, 1.0] Unit:

s 461E 17950 Parameter Drive filter order not allowed for command variable filter for the output position The value is impermissible as a drive filter order (P-Tn) for the smoothing of the output position (command variable filter for the setpoint position). Value range: [0, 10] Unit: 1 4620 17952 Parameter Bit mask for stepper motor cycle not allowed A value of the different stepper motor masks is impermissible for the respective cycle. Value range: [0, 255] Unit: 1 4621 17953 Parameter Bit mask for stepper motor holding current not allowed The value for the stepper motor holding mask is impermissible. Value range: [0, 255] Unit:

1 4622 17954 Parameter Scaling factor for actual torque (actual current) not allowed The value is impermissible as a scaling factor for the actual torque (or actual current). Value range: [0, 1E+30] Unit: 4623 17955 Parameter Filter time for actual torque is not allowed The value is impermissible as a filter time for the actual torque (or the actual current) (P-T1 filter). Value range: [0.0, 60.0] Unit: s 4624 17956 Parameter Filter time for the time derivative of the actual torque is not allowed The value as filter time for the time derivative of the actual torque (or the actual current) is not allowed (P-T1 filter). Value range: [0.0, 60.0] Unit: s