beckhoff TwinCAT 2 Motion — 2.7 Drive error

Overview of NC Errors NC Errorcodes 62 Version: 1.1 Error(Hex) Error(Dec) Error type Description 4611 17937 Parameter Profi Drive DSC proportional gain Kpc (controller) not allowed Position The value for the Profi Drive DSC position control gain (Kpc factor) is impermissible. Value range: [0, 0xFFFFFF] Unit: 0.001 * 1/s 4612 17938 Parameter Table ID not allowed The value for the table ID is impermissible. Value range: [0, 255] Unit: 1 4613 17939 Parameter Table interpolation type is not allowed The value is impermissible as the table interpolation type. Value range: 0 (LINEAR), 2 (SPLINE) Unit:

1 4614 17940 Parameter Output offset in percent is not allowed The value is impermissible as an output offset in percent (+/- 1.0). Value range: [-1.0, 1.0] Unit: % 4615 17941 Parameter Profi Drive DSC scaling for calculation of 'Xerr' (controller) not allowed Position The value is impermissible as Profi Drive DSC scaling for the calculation of 'Xerr'. Value range: [0, 1000000] Unit: 1 4616 17942 Parameter Drive acceleration output scaling not allowed The value is impermissible as drive acceleration/ deceleration output scaling. Value range: [0, 1000000] Unit: 1 4617 17943 Parameter Drive position output scaling not allowed The value is impermissible as drive position output scaling.

Value range: [0, 1000000] Unit: 1 4618 17944 Parameter Parameter 'Dead time compensation mode' (Motion Controller) is invalid The parameter for the dead time compensation mode of the NC Motion Controller is invalid (OFF, ON with velocity, ON with velocity and acceleration). Value range: [0, 1, 2] Unit: 1 4619 17945 Parameter Parameter 'Control bits of the dead time compensation' (Motion Controller) is invalid The parameter for the "Control bits of the dead time compensation" of the NC Motion Controller is invalid (e.g. relative or absolute time interpretation). Value range: [>0] Unit:

1 461A 17946 Parameter Parameter 'time shift of dead time compensation mode' (Motion Controller) is invalid The parameter for the time shift of the dead time compensation (Time Shift in nanoseconds) of the NC Motion Controller is invalid. Value range: [-1.0E9 .. 1.0E9] Unit: ns 461B 17947 Parameter Parameter 'Output delay velocity interface Motion Controller' is invalid The parameter for an optional output delay in the velocity interface to the Motion Controller is invalid (Delay Generator Velocity). The maximum permitted delay time must be less than 100 times the NC SEC cycle time. Value range: [0.0 .. 0.1] Unit: s