Overview of NC Errors 2.9 NC-PLC Errors NC Errorcodes 69 Version: 1.1 Error(Hex) Error(Dec) Error type Description The number of valid points defining a Motion Function is less than two. Either the total number is too low or the point type of many points is set to Ignore Point. 4A25 18981 Initialization Master start position of the table is invalid. For a periodic position table, it is mandatory that the master position of the table starts at zero. For a periodic motion function, the first master position must be greater than zero but not greater than the period of the table.
Error(Hex) Error(dec) Error type Description 4B00 19200 Parameter Axis was stopped The axis was stopped during travel to the target position. The axis may have been stopped with a PLC command via ADS, a call via AXFNC, or by the System Manager. 4B01 19201 Parameter The axis cannot be started The axis cannot be started because: • the axis is in error state, • the axis is executing another command, • the axis is in protected mode, • the axis is not ready for operation. 4B02 19202 Parameter Control mode not permitted No target position control, and no position area control.
4B03 19203 Parameter Axis is not moving The position and velocity can only be restarted while the axis is physically in motion. 4B04 19204 Parameter Invalid mode Examples: Invalid Direction at MC MoveModulo. _ Inactive axis parameter Position correction with MC BacklashCompensation. _ 4B05 19205 Parameter Command not permitted • Continuous motion in an unspecified direction • Read/Write parameter: unsuitable type 4B06 19206 Parameter Parameter is not correct • Incorrect override: > 100% or 4B07 19207 Parameter Timeout axis function block After positioning all "MC Move..."function blocks, check _ whether positioning was completed successfully.
In the simplest case, the "AxisHasJob" flag of the NC axis is checked, which initially signifies that positioning was logically completed. Depending on the parameterization of the NC axis, further checks (quality criteria) are used: • "Position range monitoring" If position range monitoring is active, the system waits for feedback from the NC. After positioning, the axis must be within the specified positioning range window. If necessary, the position controller ensures that the