beckhoff TwinCAT 2 Motion — 2.12 Further Error Codes

Overview of NC Errors 2.12 Further Error Codes Table 1: NC Errorcodes 79 Version: 1.1 Code Hex Code Dec Symbol Description Typical error message in the logger: "BodePlot: Sequence aborted with GUI Life Counter error 0x%x because the WatchDog timeout of %f s elapsed ('%s')" 0x8112 33042 NCERR BODEPLOT WCSTA _ _ TE WC state error (IO data working counter) IO working counter error (WC state), for example due to real-time errors, EtherCAT CRC errors or telegram failures, EtherCAT device not communicating (OP state), etc. 0x8113- 0x811F 33043- 33055 RESERVED Reserved range Error(Hex) Error(Dec) ErrorType Description 0x8120 33056 Environment Invalid configuration for Object (e.g.

in System Manager). 0x8121 33057 Environment Invalid environment for Object (e.g. TcCom-Object's Hierarchy or missing/faulty Objects). 0x8122 33058 Environment Incompatible Driver or Object. 0x8124 33060 Function Block Command execution does not terminate (e. g. MC Reset does not signal DONE). _ 0x8130 33072 Communicati on Invalid ObjectID of Communication Target. 0x8131 33073 Communicati on Communication Target expects Call in different Context. 0x8132 33074 Communicati on Invalid State of Communication Target. 0x8134 33076 Communicati on Communication with Communication Target cannot be established. 0x813b 33083 Parameter Transition Mode is invalid.

0x813c 33084 Parameter BufferMode is invalid. 0x813d 33085 Function Block Only one active Instance of Function Block per Group is allowed. 0x813e 33086 State Command is not allowed in current group state. 0x813f 33087 Function Block Slave cannot synchronize. The slave cannot reach the SlaveSyncPosition with the given dynamics. 0x8140 33088 Parameter Invalid value for one or more of the dynamic parameters (Acceleration, Deceleration, Jerk). 0x8141 33089 Parameter IdentInGroup is invalid. 0x8142 33090 Parameter The number of axes in the group is incompatible with the axes convention. 0x8143 33091 Communicati on Function Block or respective Command is not supported by Target.

0x8144 33092 State Command queue full. Command queue is completely filled up and cannot accept additional commands until some commands are fully processed. 0x8145 33093 Function Block Mapping of Cyclic Interface between NC and PLC is missing (e.g. AXIS REF, AXES GROUP REF, ...). _ _ _ 0x8146 33094 Function Block Invalid Velocity Value. The velocity was not set or the entered value is invalid.