IP67 Charger — 7.3. Instant readout

Blue Smart IP67 Charger 7.3. Instant readout The Blue Smart IP67 Charger range features instant readout functionality (requires firmware v3.61 or above), which enables the essential data and notifications from multiple compatible devices to be monitored directly in the VictronConnect device list, without the need to establish a full Bluetooth connection with the device. The key benefits of instant readout over a traditional full Bluetooth connection are: A. All essential data is displayed within the instant readout, making it unnecessary to establish a full Bluetooth connection for most monitoring requirements B.

Faster and easier means to monitor essential data, as there is no need to establish a full Bluetooth connection and navigate between screens C. Data from multiple compatible devices can be simultaneously monitored in real-time and compared on a single screen, eliminating the need to connect to multiple devices in succession and try to remember data D. Instant readout transmission range is longer than a full Bluetooth connection, since there is only one way encrypted data transmission, as opposed to two way communication The Blue Smart IP67 Charger will display the following data directly in the VictronConnect device list via instant readout: A. Output voltage B. Output current C.

Charge stage D. Warning and alarm notifications E. Error notifications Instant readout transmission is disabled by default, and can be enable using a Bluetooth enabled device (mobile phone or tablet) with the VictronConnect app. To enable instant readout: 1. Connect the Blue Smart IP67 Charger AC power cable to a mains power outlet; after a short delay the POWER LED will illuminate and the STATUS LED will begin to blink fast. 2.

Using a Bluetooth enabled device (mobile phone or tablet), open the VictronConnect app and locate the Blue Smart IP67 Charger in the Device list Local page, then connect to the device (the default PIN code is stated on a label located on the back of the charger, or try 000000 if there is no label). Page 52 Monitoring