Blue Smart IP67 Charger 9.
Technical specifications Page 64 Technical specifications Electrical 12/7 12/13 12/17 12/25 Mains power voltage (Nominal | Min/Max) 220 - 240VAC | 180 - 265VAC Mains power frequency (Nominal | Min/Max) 50 - 60Hz | 45 - 65Hz Power factor >0.6 Standby power 0.5W Max efficiency 93% 95% Normal 14.4V | 13.8V | 13.2V Charge voltage (Absorption | Float | Storage) High 14.7V | 13.8V | 13.2V Li-ion 14.2V | N/A | 13.5V Temperature compensation (N/A for Li-ion) -16mV/°C (-9mV/°F) Charge algorithm 6-stage adaptive (3 stage for Li-ion) Charge current limit Max 7A 13A 17A 25A (in selected mode) Low 2A 4A 6A 10A Max battery capacity (≥0.1C in max mode) 70Ah 130Ah 170Ah 250Ah Min battery capacity - Lead-acid Max 23Ah 43Ah 57Ah 83Ah (≤0.3C in selected mode) Low 7Ah 13Ah 20Ah 33Ah Min battery capacity - Li-ion Max 14Ah 26Ah 34Ah 50Ah (≤0.5C in selected mode) Low 4Ah 8Ah 12Ah 20Ah Start interrupt output (12/25(1+Si) model only) 0,5A max | Up to 1V below the charger output voltage Fault protection Reverse polarity (fuse), output short circuit and over temperature Communication Bluetooth (via VictronConnect app) Bluetooth power and frequency +4dBm | 2402 - 2480MHz Cooling Convection (no fan) Operating temperature range -20 to 60°C (-4 to 140°F) with full rated output up to 40°C (104°F) Max humidity 100% Physical Material and colour Aluminium | Blue RAL 5012 Mains power connection 1.5m (5ft) mains cable with CEE 7/7, BS 1363 or AS/NZS 3112 plug Battery connection Type 1.5m (5ft) figure-8 red/black cable with M8 ring terminals Cable 12 AWG 9 AWG Output fuse rating Internal No No 35A 30A (Internal fuse is not serviceable) Cable 20A 20A 30A No Ingress protection (IP) rating IP67 Weight 1.8kg (4.0lb) 2.4kg (5.3lb) Dimensions (h x w x d) 85 x 211 x 60 mm (3.3 x 8.3 x 2.4 inch) 99 x 219 x 65 mm (3.9 x 8.6 x 2.6 inch) Compliance Safety EN 60335-1, EN 60335-2-29 EMC ETSI EN 301 489-1 V2.2.3, ETSI EN 301 489-17 V3.2.4, ETSI EN 300 328 V2.2.2 Automotive ECE R10