Chapter 4: BIOS Hot Plug This feature designates the SATA port specified for hot plugging. Set this item to Enabled for hot-plugging support, which will allow the user to replace a SATA disk drive without shutting down the system. The options are Disabled and Enabled. External SATA Use this feature to disable or enable external SATA support. The options are Disabled and Enabled. Spin Up Device On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRESET initialization to the device. The options are Disabled and Enabled. SATA Device Type Use this item to specify if the sSATA port specified by the user should be connected to a Solid State drive or a Hard Disk Drive.
The options are Hard Disk Drive and Solid State Drive. Topology Use this feature to configure the SATA Topology. The options are Unknown , ISATA, Direct Connect, Flex, and M2. Thermal Configuration Platform Thermal Configuration Automatic Thermal Reporting Set this feature to Enabled for automatic thermal reporting. Set to Disabled to manually configure the thermal reporting. *If this feature is set to Disabled, Critical Trip Point is available for configuration: Critical Trip Point Use this feature to set the value that controls the temperature of the ACPI Critical Trip Point.
The options are 15 C, 23 C, 31 C, 39 C, 47 C, 55 C, 63 C, 71 C, 79 C, 87 C, 95 C, 100 C, 103 C, 111 C, 119 C (POR) , and 127 C. Active Trip Point 0 Use this feature to set the temperature of the ACPI Active Trip Point 0 that turns on the processor fan. The options are Disabled, 15 C, 23 C, 31 C, 39 C, 47 C, 55 C, 63 C, 71 C , 79 C, 87 C, 95 C, 103 C, 111 C, and 119 C (POR). 75