Chapter 2: Installation CMOS Clear (JBT1) JBT1 is used to clear the saved system setup configuration stored in the CMOS chip. To clear the contents of the CMOS, completely shut down the system, remove the AC power cord and then short JBT1 with a jumper. Remove the jumper before powering on the system again. This will erase all user settings and revert everything to their factory-set defaults. PCI Slot SMB Enable (I 2 C1/I 2 C2) PCI Slot_SMB Enable Use Jumpers I 2 C1/I 2 C2 to enable PCI SMB (System Management Bus) support to improve system management for the PCI slots. See the table on the right for jumper settings.
Jumper Setting Definition Jumper Settings Short Enabled Open (Default) Disabled A. Clear CMOS B. JI 2 C1 C. JI 2 C2 C B A 2-33